User Manual

3. Instrument View
You can also select parameters by opening your plug-in interface. For that you need to click on the button.
Above your plug-in interface, you can see 8 numbers. 
Each number corresponds to a Slot. Click on a number then move one of the parameters from your plug-in (a knob,
a slider …). The chosen parameter is now mapped to the corresponding Slot, as indicated by the new colour line
surrounding the number.
To go faster, you can use the speedmapping : clicking on it allows you to directly select 8 parameters from your
plug-in interface, and link them -in the order you selected them- to each Slot.
You can un-map any parameter by clicking on the colour circle.
3.2.7. MIDI Setup
The MIDI Setup allows you to assign MIDI messages to Touché SE shiings when you use Touché SE without Lié.
Click on “MIDI Setup” button in the Menu to open it.
For each slot you can assign a sensor of Touché SE to a specific CC message by selected it from the drop-down list
above each slots. Like in a soware preset, you will be able to access shiing selection, min/max and curves.
In this panel, you can also select the MIDI channel output of Touché SE for this configuration in standalone mode.
When you’re glad of your configuration, click on SAVE SETUP to save it in the device.
When you open the MIDI SETUP, the panel display the actual configuration of your Touché SE."
Expressive E
Touché SE User Manual v.1
Page of 18 36