Instructions / Assembly

Water Storage Tank

NOTE! Do not tamper with the air valve on the lower side of

the Water Storage Tank. It has been preset at 7-10 PSI.

1. Open the Water Storage Tank box and unscrew the Tank Stand

from the threaded em at the top of the Tank.

2. Wrap the threaded em 8-10 times with Teon Tape.

3. Screw the Tank Valve onto the threaded em. Make sure it is

tight, but do not over tighten.

4. Place the Water Storage Tank near the RO Syem in the de-

sired location. The Tank can and up raight or lie on its side.

5. Connect the Yellow Tubing to the Stem Run Tee of the Inline

Po Carbon Filter, then to the Tank Valve (See I to J on Page 23).

6. Keep the Tank Valve in the Closed Position until Syem Startup.

NOTE! If after 3-5 hours your tank does not ll: Connect the tank

directly to the cold water supply (bypassing the RO Syem) and

allow the tank to ll for about 1 minute. Then reconnect to your

syem as normal and empty the tank through faucet. This will

help activate the tank bladder.

NOTE! The Tank Valve only controls

water leaving the Water Storage Tank.

To op all incoming water use the

Feed Water Adapter Valve.

A. Tank Thread

B. Tank Valve

OPEN POSITION

C. Tank Stand

CLOSED POSITION