Instructions / Assembly

15
2. As shown below, the Feed Water Adapter Valve can be used for 3/8” or 1/2” feed line plumbing.
Next, use an adjuable wrench to secure the Adapter Valve either directly to the Cold Water Valve
Option A or further up in the line before the faucet Option B (if applicable).
Make sure your Adapter Valve is in the closed position when inalling it.
Using the Feed Water Adapter Valve
During inallation leave your Feed Water Adapter Valve in the “CLOSED” position until Syem Startup.
The Feed Water Adapter Valve controls all water coming into your RO Syem. If for any reason you need to
op incoming water turn the Feed Water Adapter Valve to the “CLOSED” position. Always turn this valve o
before replacing lters, if a leak is discovered, or when shutting down the syem.
CLOSEDOPEN
WARNING!
INCOMING WATER PRESSURE
SHOULD NOT EXCEED 80 PSI
NOTE!
Do Not Use Teon Tape!
Use your wrench to tighten the connection, be careful not to over tighten.
Simply switch the Adapter Nut
(see left image) from one side of
the Adapter Valve to the other.
3/8” Connection1/2” Connection
Adapter
Nut
Adapter
Nut