Instructions / Assembly

9
1. Please wipe the machine with a soft cloth.
2. For stubborn stains or dust, use a soft cloth with warm water.
3. Do not use volatile liquids like alcohol, gasoline, paint thinner, polishing powder, or other materials, as they may damage the
machine’s surface.
4. Do not wash the exterior or interior of the product with water. Rinsing the interior with water may cause water accumulation,
leading to odors and bacterial growth.
If you don’t plan to use the machine for an extended period:
1. Empty the water tank.
2. Press and hold the button for 2 seconds to drain the water until the icon disappears.
3. Disconnect the power supply.
When using the machine again:
1. Clean the water tank, ll it with tap water, and plug in the power supply. Wait for it to produce water.
2. Press and hold the button for 2 seconds to drain the water until the icon disappears. It’s recommended to rinse a
bucket of water.
3. Follow the “System Use” operation method for normal use.
DAILY MAINTENANCE
SYSTEM
MAINTENTANCE
If you see the screen displaying C1, the machine is currently producing water. You may not be able to dispense water at this
moment, so please be patient. After waiting for approximately two minutes, you can try dispensing water again.
When the screen displays C2, it means that the water tank is running low (when the water level falls below the water level line).
You can resolve this issue by opening the top cover of the water tank, lifting out the water tank, pouring out the remaining water,
and lling it up with new tap water. After you close the machine and its top cover, the machine will return to normal use (note: if
you recycle the old water this can cause the membrane to foul over time).
If the screen displays E1, it indicates a system malfunction, and the fault light will ash. To x this, you need to put the water tank
back into the machine and cover it with the water tank cover. This will eliminate the alarm and allow the machine to continue
functioning normally.