Instructions / Assembly

8
SYSTEM
USE
Q: Why isn’t the water hot?
A: No need to panic! The
system is designed this way.
Simply run the procedure
again to obtain hot water.
Water Dispensing Procedure:
To ll the water tank, repeat steps 2 and 3 in the “Before Use” section and plug in the machine.
If the device is in sleep mode, simply touch any key on the screen to wake it up.
To unlock, press and hold the child lock button for 1 second.
To lock it, lightly touch the button.
UV Function:
1. After powering on, the UV sterilization indicator will light up, and the sterilization process will continue for 1 hour.
2. After each water production cycle, sterilization for 10 minutes will be carried out.
3. If the device is in standby mode for more than 50 minutes, the sterilization process will be performed for 10 minutes, and this
cycle will repeat in standby mode.
Temperature Selection - you can choose between two temperature modes:
F
AMBIENT WARM HOT
First Cup of Hot Water:
When the screen displays C3, the rst cup of hot water will be at room temperature every time the power is turned on. So, when
you want to drink hot tea, don’t worry. Just start the procedure again.
Water Outlet Mode Selection:
Room
Temperature
113°F
(45°C)
203°F
(95°C)
Shortcut Mode Custom Mode
Click to add or subtract 1 degree;
long press to speed up adjustment.
Shortcut Mode Custom Mode
beep
beep beep
AMBIENT WARM HOT
Room
Temperature
113°F
(45°C)
203°F
(95°C)
Small Cup
4oz (120ml)
Large Cup
8.5oz (250ml)
Press cup to select, then press Water Button.
When at preset limit, water stops.
Dispense water Press again to stop
Dispense water
Example - water for hot tea: