Instructions / Assembly

Note: For the rst use, it is recommended to repeat steps 1, 2, and 3 to ush the entire machine and the lter element.

We suggest ushing with three buckets of water. This process may take some time, so please be patient. The rst

ush is to clean the lter element and pipeline, and the water may appear gray-black or bubble-like, which is normal.

Continue to ush until the water runs clear.

Step 1: Unlock

Press and hold the child lock button

for one second to unlock the full

screen.

Step 2: Water production mode, the

screen displays C1.

The machine will start producing water

for the rst time. Please be patient and

wait for approximately 13 minutes.

Step 3: One-key emptying

Press the button to empty the water

in the pure water tank inside the

machine.

4. Flushing the lter element

1. Placement

Open the packaging box and remove the entire machine,

placing it on a table. Take the water collection box from

the package and insert it into the card slot of the machine.

2a. Filling the water tank

Open the upper cover

of the water tank and

lift out the tank. After

rinsing the tank, ll

it with an appropriate

amount of water,

ensuring that the water

level remains below

the maximum scale but

above the minimum line.

3. Powering on

Place the water tank into the machine, close the top cover,

and plug in the power.

2b. Note: When lling the water tank, ensure that both

the raw water area and the waste water area are lled

up to the highest water level (as shown in the picture).

BEFORE USE

Pull up the

handle to lift out

the water tank

Put in the

water tank