Use and Care Manual

ALK or DI Change
(Recommended change 6 months)
1. Now disconnect the Stem Elbows from each side of the filter.
2. Note the orientation of the old filter, install the new filter in the same orientation. Remove the old filter from the
holding clips and discard. Next, insert the new filter into the holding clips and connect the Stem Elbows to the new filter.
System Restart
1. Fully open the Feed Water Adapter Valve, Cold Water Supply, and the Tank
Valve.
2. Open the RO Faucet handle and fully empty the tank before turning the Faucet
handle off.
3. Let the system refill with water (this takes 2-4 hours). You can open the RO
Faucet briefly to release any air trapped inside the system while it’s filling. (Be sure
to check for new leaks during the first 24 hours after restarting)
4. After the Water Storage Tank has filled drain the entire system by opening the
RO Faucet until the water flow is reduced to a slow trickle. Then close the Faucet.
5. Repeat steps 3 and 4 three times to fully flush the system (6-9 hours)
UV Change
(Recommended change 6-12 months)
1. Unplug the power cord from the power outlet. DO NOT Unscrew the metal cap.
2. Carefully and slowly pull the black plastic cap off the UV Sterilizer (the bulb may come out with the cap, if it does not tilt
the system until the white ceramic portion of the bulb is accessible).
3. Unplug the power cord from the UV Bulb and dispose of the old bulb.
4. Connect the new UV Bulb to the power cord.
5. Carefully push the new UV Bulb into the UV Housing though the opening in the metal cap. Then slowly push the black
plastic cap back on to the sterilizer.
6. Reconnect the power cord to power outlet.
NOTE! If the RO System is connected to a refrigerator do not drain the system through the refrigerator water dispenser.
The excess carbon fines from the new carbon filter will clog the internal fridge filter.
UV Housing
UV Bulb
UV Ballast