Use and Care Manual
21
1. Before you begin you will need a new Filter Set, Filter Housing Wrench, and a container to mix water and
bleach. We also sugge using a bucket or bin large enough for the syem to sit in (the syem will release a lot
of water when it is disassembled).
2. Close any incoming water (Feed Water Adapter Valve page 11).
3. Open the Drinking Faucet handle and drain the syem completely (wait until water ow ops), then close
the Faucet handle.
4. Use the Filter Housing Wrench to open the Filter Housings, then remove and dispose of the lters.
5. Mix 1 gallon of water with 2 tbsp of household bleach. Do not add bleach directly to the lter housing.
6. Fill up the Filter Housings with your mixed solution and close the housings using your Filter Housing Wrench.
7. Open the drinking water faucet handle then open the incoming water to the syem (Feed Water Adapter
Valve page 11) and let it run for 10 minutes.
8. Close the faucet handle and wait for 5 minutes then open the faucet handle again and wait 10 more minutes.
If you smell bleach from your Drinking Faucet repeat eps 7 & 8
9. You are now ready to replace all lters and reart your syem. Please refer to page 22 for detailed
inructions, ignore any additional sanitation eps therein.
How to Sanitize your RO System
(Recommended Once a Year)