Use and Care Manual
20
Filter Change Instructions
This Syem uses Filters that mu be replaced at regular intervals to maintain proper performance.
How to Change the SED, GAC, and ACB
(Recommended about every 6 months)
1. You will need a clean cloth, dish soap, and appropriate
Filters. We also recommend a bucket or bin large enough for
the syem to sit in. The syem will release water when it is
disassembled.
2. Turn o the Cold Water Supply connected to the Syem
(refer to page 11), and the Feed Water Adapter Valve (page
12). Then open the Drinking Faucet handle to release pressure,
close handle when the ow of water ops.
3. Place the syem in the bucket and unscrew the Filter Housings using the Filter Housing Wrench. Remove
old lters and dispose of them.
4. Wash the Filter Housings with dish soap then proceed to rinse until all soap is removed.
5. Ensure your hands are washed clean before unwrapping the new lters. After unwrapping, place the new
lters inside their correct housings. Make sure the O-Rings are in their proper locations.
6. Tighten the Filter Housings using the Filter Housing Wrench. Do not overtighten. If these are the only
lters you are replacing continue to the Rearting the Syem section on Page 20.
ACB SEDGAC
Restarting The System
1. Fully open the Feed Water Adapter Valve and Cold Water Supply
2. Open the Drinking Faucet handle for 10 minutes before turning the faucet o.
3. Let the syem sit for 3 hours.
Be sure to check for new leaks during the r 24 hours after rearting
4. Run the drinking water faucet for 10 more minutes.
5. Now your water is ready to drink!
NOTE! If the Syem is connected to a refrigerator do not drain the syem through the refrigerator
water dispenser. The excess carbon nes from the new carbon lter will clog the internal fridge lter.