Use and Care Manual

16
Elbow Fitting In󰎣allation
1. Screw a Male Elbow Fitting into the top of
the SED Filter Housing (marked “IN”). Screw
until tightened and the arm of the Elbow is
facing downward.
2. Push the White Tubing into the Male Elbow
Fitting. Push hard enough on the tubing to
make sure the Quick Connect has locked
before moving on.
3. Screw the other Male Elbow Fitting (with the
red plug) into the top of the ACB Filter Housing
(marked “OUT”). Screw until tightened and the arm
of the Elbow is facing upwards at an 11 O’Clock
angle (use image 4 for reference).
4. Remove the red plug from the Male Elbow
Fitting, then push the Red Tubing into the
Elbow. Push hard enough on the tubing to
make sure the Quick Connect has locked
before moving on.
NOTE! Secure all connections with Blue Locking Clips once nished.