Owner`s manual

www.exposurelights.com
9
SMART CHARGING MaXx
2
LIGHT
Before riding with your Exposure MaXx2 light please charge it fully. Follow
the recharging instructions below.
Use only genuine Exposure Lights chargers. International socket chargers
are available, also in-car charger.
EXPOSURE LIGHTS use the highest quality Lithium Ion batteries, which
have no charge memory. This allows them to be recharged at any point
during the discharge cycle. Burn times will not be affected by multiple
re-charging.
RE-CHARGING INSTRUCTIONS
•
Ensure the light unit is turned off.
•
Plug the MaXx Smart Charger into the wall socket and switch on the wall
socket. The LED on the charger will show green (operational).
•
Insert the charger connection plug into the charge port,
located on the back of the light.
The charger LED will
show red when the light
unit is charging.
The function button on the
light will continuously flash
green to inform you that the
charger is connected and
functioning.
From empty the light unit will rapid charge to
approximately 90% capacity - at this point the LED on
the charger will go from red to green.
To 100% charge the light leave the charger plugged in and turned on for
a further 1 to 4 hours depending on the model (see below). You can leave
the light on charge for longer if you like and it will not be a problem. Just
like your mobile phone.
charge port
function button
Long periods of non-use will lower the voltage of the battery. If the unit
is being stored for long periods, please ensure the battery is periodically
charged. We suggest once per month.
All the Exposure MaXx models use the same Smart chargers.
Rapid (red) Trickle (green)
90% Final 10%
Joystick 3 Hrs 1 Hrs
Race 6 Hrs 2 Hrs
Enduro 9 Hrs 3 Hrs
MaXx-D 12 Hrs 4 Hrs
Charge Capacity