Owner`s manual

www.exposurelights.com
8
Function
button
Button Battery
Green 100% - 50%
Amber 50% - 25%
Red 25% - 5%
Red Flash 5% - Empty
LIGHT OPERATION
Function Button
Located on the back of the
light unit is the function button.
This operates the light unit
and informs you of the mode
setting and the battery power
status.
When the light is on and function button is pressed, the colour of the
button for the first two seconds informs you which mode has been
selected. Thereafter the colour of the button is your fuel gauge.
Mode Function
•
To turn on the light, double click the button; the light is now operating in
the brightest MaXx mode.
•
To switch between the constant settings, press the button once.
•
To activate the flashing mode, press and hold the button for 1 flash
(approx 1 second) and release. The flashing mode can be activated
from any of the constant modes. To return to the MaXx mode, press the
button once.
•
To turn off the light, press and hold the button down. After 2 flashes
(approx 2 seconds) the light will turn off. The function button will rapid
flash red as the circuit board shuts down.
The colour of the function button will show which light mode you are in for
the first two seconds after the button is pressed.
Green (MaXx) – Amber (Ride) – Red (Low).
Fuel Gauge Function
After two seconds the function button becomes the fuel gauge. The colour of
the button now indicates the approximate percentage of battery power left.
When the battery has only 5% charge remaining in whichever mode,
the light will automatically switch to the low setting. Modes available are
restricted to Ride and Low. The function button will flash red. Light output
will slowly dim over 3 hours and this is the extended burn time on reserve
power.