Owner`s manual

www.exposurelights.com
7
How to Mount the EXPOSURE Joystick MaXx
2
.
Helmet mounted
The highly acclaimed Joystick helmet bracket works as a ball joint. Follow
these instructions for set up and position the light for riding. The clamp
is made up of three parts: Lower clamp disc, upper clamp with ball joint
socket and a nylon clamp bolt.
•
Put the shorter plastic bolt through the lower clamp disc and align with a
selected vent on the inside of your helmet.
•
Place the upper clamp through the top of the
vent to meet the bolt.
•
Tighten the bolt. Take care not to damage your
helmet.
Use the shorter bolt first and if not long enough
then go to the longer bolt. Do not use the long bolt
on thinner section helmets, as this will stop the
ball joint working or possibly pop it out.
•
Clip the Joystick body into the top part of the clamp
•
The Joystick can be adjusted by rotating the ball joint when holding the
light and is easy to do when you are riding to get the best position.
If you are worried about losing your Joystick in a crash or when riding
under low objects then we suggest you attach a lanyard through the holes
provided at the back of the light unit and loop the lanyard through a vent in
your helmet or round the handlebar if using it there.
Handlebar mounted
The new Joystick QR Clip now allows you to mount your Joystick to the
same Quick Release bracket as used by the rest of the light range.
Simply press the Joystick into the QR clip
with the point of the clip towards the front of
the light
Now engage the clip and light into the
QR bracket as previously shown for other
models.
EXPOSURE LIGHTS/USE accepts no liability for any injuries or other
damages to person or equipment arising from the use of the clamps.