Owner`s manual

www.exposurelights.com
6
How to Mount the EXPOSURE Race & Enduro MaXx
2
models to the bar
•
Mounting to a 31.8mm bar - Peel off backing of the rubber protection
strips and attach the pads to the inside of the clamp. Attach the bracket
to the bar. Tighten the clamp with a 4mm hex key. (Maximum 2.5Nm)
DO NOT OVER TIGHTEN!
•
Mounting to a 25.4 or 26mm bar - Clip the bracket spacer over your bar,
attach the bracket over the spacer and tighten the clamp with a 4mm hex
key. (Maximum 6 Nm) DO NOT OVER TIGHTEN!
•
To release the light from the bracket
push away and down on the red
button and gently pull back the light
with your hand. This is a simple one-
hand operation.
•
Attach the cleat to the light unit using
the provided bolt.
•
Locate the cleat into the V section of
the bracket - the sprung loaded pin
will depress as it is pushed into place.
•
To adjust the angle of the light beam
release the cleat bolt. A hole in the
bracket enables access to the bolt
head. Use a 4mm hex key to adjust
the light and tighten the bolt securely
(Maximum 2.5Nm)
•
Warning - Make sure that brake and gear cables cannot catch on or
interfere with the light or the bracket or release button.
•
Warning: Racers beware - check number boards do not interfere with
bracket button.