User Manual

Choose Run Mode
The operating mode is set in menu RUN MODE. For operation on a DMX-controller DMX needs to be
set. SLAVE sets the fixture into slave mode.
MENU
Edit User Programs
In the menu EDIT the user programs PROGRAM1 to PROGRAM10 can be edited. Every program
can have up to 30 steps (SCENE-01 - SCENE-30). Every step persists of the parameter colours
RGBW, ZOOM, STROBE „0-20Hz“, TIME and FADE. User programs can be transfered to other
fixtures (see master/slave).
Step-by-step programming of the custom stand-alone programs with up to 30 different steps.
NOTE: For less than 30 steps the TIME and FADE of the last step needs to be set to 0.
Example for time settings of a stand-alone programm with 3 steps:
Step 1 TIME = 4 FADE = 3
Step 2 TIME = 5 FADE = 2
Step 3 TIME = 0 FADE = 0
MENU
E-27
PERSON
RUN MODE
HSICDMX
HSIC
SLAVE
HSICEDIT
PROGRAM1
PROGRAM2
o
o
o
PROGRAM10
SCENE-01
SCENE-02
SCENE-30
o
o
o
RED
GREEN
BLUE
WHITE
ZOOM
STROBE
R.(0 - 255)
G.(0 - 255)
B.(0 - 255)
W.(0 - 255)
Z.(0 - 255)
S.(0 - 25)
TIME
FADE
T.(0 - 255)
F.(0 - 255)
Zoommode auswählen
In the ZOOM MODE menu the speed of the motorised zoom is set. In ZOOM MODE1 the Zoom runs
at maximum speed, in ZOOM MODE2 it runs slower but with less loudness.
MENU
PERSON
ZOOM MODE
HSIC
ZOOM MODE1
HSIC
ZOOM MODE2