User Manual

camera to select the custom WB icon in control panel

10. Remove the ExpoCap, return camera to auto focus mode if desired, and start shooting

Nikon D70, D70s and D50 Custom White Balance Procedure

1. Use an automatic exposure (AE) setting such as the “P”, “S” or “A” modes to ensure a correct

white balance exposure through the ExpoCap

2. Install the ExpoCap

3. Set camera to Manual Focus mode

4. Push and hold ‘WB’ button with left thumb while turning right thumb wheel to select ‘Pre’ in the

control panel, then release ‘WB’ button

5. Push and hold ‘WB’ button again until ‘Pre’ begins to blink in the control panel (3 seconds)

6. While ‘Pre’ is blinking (10 seconds), aim camera towards light source or scene to balance and

press the shutter release button

7. ‘Good’ will replace ‘Pre’ in the control to indicate a successful white balance capture

8. If ‘no good’, then repeat steps 5 and 6 until you see ‘good’ flash in the control panel (too much, or

too little light may result in a ‘no good’ reading)

9. Press the shutter release button to exit menu functions

10. Remove the ExpoCap, return camera to auto focus mode if desired, and start shooting