Data Sheet

Bella Barista
Nene Court, The Embankment,Wellingborough, Northants, NN8 1LD
Tel: [phone]
e-mail: [e-mail]
© Bella Barista Page 7 of 12
Brew Pressure (factory preset is a little
high)
With the blind filter in place, it was a little above 12 bar.
Plumbed in or tanked operation switched
via a simple lever and valve, a great idea
and so easy. You don’t have to remove
the case, just reach underneath the
machine
Possibly the right design
model for all domestic
prosumer machines. It’s great
to have a choice that can be
so easily made! And great at
decaling time if you have
plumbed it in!
The rubber feet are nice quality, but do
grip well.
A bit annoying when pulling it in and out to fill it with water.
Fortunately these feet can easily have a “glide pad” or felt
furniture pads fitted or even the use of castor cups with “glide
pads” fitted. Moving the machine then becomes easy
Water & steam valves had a nice feel,
the knobs were a good size and the
wands being mounted on ball joints is a
real bonus.
Separate brew pressure and boiler
pressure gauges. They look smart too
Nice quality steel case & frame
Wiring routed neatly
Giemme control Unit
Accessible pressure stat
Insulation on the boilers is a great idea it
certainly will prevent heat loss and helps
keep the components cool.
OPV valve adjuster
Pump quite accessible and easy to
change. Ulka EX5 48W.
Nice sturdy feet easy to adjust to level
machine
Pump replacement should be a
straightforward job
All components very accessible. This
should make servicing quick and easy.