Data Sheet

Bella Barista
Nene Court, The Embankment,Wellingborough, Northants, NN8 1LD
Tel: [phone]
e-mail: [e-mail]
© Bella Barista Page 6 of 12
Water tank platform and shield has a
protective film on the inside surface.
Personally I decided to remove this
Expobar should remove this
prior to assembly, although to
be honest I don’t think it will
cause a problem, melt or fall
off.
Small hole in water tank a blessing and a
curse. The tank is well made and good
quality
Means that crud doesn’t fall
easily into the tank and water
doesn’t slop over the sides
when moving it (in fact you
can fill it right up.
The small hole however does
make it more difficult to fill
and much more difficult to
clean (so don’t go on holiday
for 2 weeks with it full of
water!)
When low on water machine just switches
off.
A warning bleeper like the Vivi which starts beeping even
though the machine switches off.
I hate it when the espresso shot just
stops.
Second Micro switch to illuminate a low water buzzer or light
a few oz before the machine will switch off due to low water
level. Or a dual pole/position micro switch to replace existing
one
The badge looked great, not all metal, but
looked the right size and quality for the
machine
One of my pet hates, are
these cheap looking labels
some manufacturers use.
This badge looked nice on
the machine!
Removing the outer case was easy There are 5 screws, and the water tank platform (which may
also need to be removed) has two screws and a couple of
hex screws (puzzling why they decided to use 2 hex
screws?).
Wiring all braided and high quality It’s good, not as neat as an Izzo, but then so far no machine
has come close to the neatness of Izzo wiring