Specifications

9-14
HOW TO USE YOUR MOTORHOME’S
EQUIPMENT
13
about 2 litres, which is about three uses. It is
advisable to empty the waste tank earlier.
Note: Do not allow the waste tank to become
too full.
9. Make sure that the valve blade is closed.
Open the access door located outside the
vehicle. Pull the safety catch upwards and
remove the waste tank.
Remove the water filling extension first to
avoid it getting lost during emptying of the
waste tank.
10. Stand the waste tank upright (pull-out handle
at the top, wheels at the bottom). Press the
handle down and move it away from the
waste tank until it snaps out of its locked
position.
11. Pull the handle up and wheel the waste tank
to an authorised waste dump.
12. Push the handle back. Turn the emptying
spout upwards and remove the cap from the
spout. Hold the waste tank by the upper
handle with one hand, while placing your
other hand by the rear handle so that during
emptying you can operate the vent plunger
with your thumb. To empty the tank without
splashing, depress the vent plunger while
emptying the tank. After emptying, flush the
tank thoroughly with water. Also clean the
valve blade with water.
Note: The vent plunger should only be pressed
once the emptying spout is pointing downwards!
13. If required make the toilet ready for use
once again. Return the water filling extension
to its original position on the waste tank.
Slide the waste tank into the toilet and close
the access door.