Specifications

6-4
GETTING STARTED
ROAD SAFE GAS REGULATOR
Operating instructions
The use of upright gas cylinders from which gas is
taken in the gas phase is mandatory for the
operation of gas regulators, gas equipment and
gas systems. Gas cylinders from which gas is
taken in the liquid phase (e.g. for fork lifts) must
not be used, since they would result in damage to
the gas system.
Taking into operation
Open gas remote switch if present.
1. Open the cylinder’s valve.
2. Firmly press the green reset button on the
high pressure hose.
3. Press gas flow monitor reset button (green
button) on gas pressure regulator slowly.
4. Release gas flow monitor reset button (green
button) on gas pressure regulator slowly (3
seconds). If no pressure point is felt when the
button is pressed again, the regulator is ready for
operation (repeat procedure if necessary). Start
the gas-burning devices if desired. If the gas
cylinders are closed, SecuMotion may switch off
after an extended period of no usage.
Changing a gas cylinder
Please use the included screwing tool to attach
and remove the high pressure hoses. It will help
you generate the necessary tightening torque and
will prevent damage to the screw fittings, which
may otherwise result from using an improper
tool.
Residual gas: No smoking! No open flames!
- Close the empty gas cylinder’s valve.
- Remove the high pressure hose from the gas
cylinder and remove the clip-on adapter, if
present.
- Attach the high pressure hose to the full gas
cylinder and apply the clip-on adapter, if present.
- Open the full cylinder’s valve.
- Press the hose-break safety device and the gas-
flow monitor (see “Taking into operation”).
Anytime after making changes, check the hose
connection to the cylinder valve for leaks (see
“Checking for leaks in the high pressure area”).
Exchanging hoses.
Please use the included screwing tool to attach
and remove the high pressure hoses. It will help
you generate the necessary tightening torque and
will prevent damage to the screw fittings, which
may otherwise result from using an improper
tool.
Residual gas: No smoking! No open flames!
- Close the gas cylinder’s valve.
- Remove the high pressure hose from the gas
cylinder (or from the slip-on adapter) and from
the regulator inlet.
When performing a hose change, please ensure
that the white gasket provided with the hose
(hose outlet - regulator inlet) is correctly
installed and not damaged.
We recommend that the gasket (part no. 50020-
76300) be replaced with every hose change.
- Screw country-specific high pressure hose to
SecuMotion inlet and cylinder (or to adapter).
Open the gas cylinder’s valve.
- Press the hose-break safety device and, if
necessary, the gas-flow monitor (see “Taking into
operation”).
Anytime after making changes, check the hose
connections to the cylinder valve and to the inlet
of the SecuMotion gas-pressure regulator for
leaks.