Specifications

1) Main switch (see minimal voltage control).
2) Test button to check the voltage of the car
(B1) and leisure (B2) battery.
3) Test button to check the level in "%" of the
drink water tank. 4) Lights main switch.
5) Awning light switch, it switches
automatically off when you start up the
engine.
6) Water pump switch.
7) Digital displaying of the required test.
8) It shows the starting up of the battery
parallel when the engine is started.
9) It shows the car (B1) battery test, the
blinking means run-down battery alarm.
10) It shows the leisure (B2) battery test, the
blinking means run-down battery alarm.
11) It shows the battery recharging through
engine alternator.
12) It shows the test or alarm batteries
together with the symbols 9 or 10.
13) It shows the connection to the 230V net.
14) It shows that the minimal voltage device
has switched on.
15) It shows the drink water tank test, the
blinking means empty tank alarm.
16) The blinking shows the full waste water
tank.
17) It shows the unit of measure: U=Volt,
I=Internal temperature, E=External
temperature.
18) It shows the temperature unit of measure.
DIP-SWITCH POSITION
Attention: Do not change the position as
shown in figure.
20
CONNECTING SERVICES - ELECTRICITY
ON 1 2 3 4
AUTOSTRATUS/CASTAWAY CONTROL PANEL “PC-200”