Specifications

must be kept clear of dirt and snow
slush.
2. Before switching on the heater in
winter, clear all snow from the cowl.
Refer to manufacturer's operating
instructions for winter use.
3. Inspect the exhaust duct and all
connections at regular intervals, and
always in the event of blowback
(misfire). Never place any object on the
exhaust duct, since this could result in
damage.
4. Never allow the warm air outlet on
the heater to be obstructed in any
way.
For instance never hang washing on or
in front of the heater to dry. Misusing
your heater in this way could cause
serious damage from overheating. Do
not place flammable objects near the
heater. Please follow these guidelines
in the interest of your own safety.
5. Due to the design, the heater
cladding will become hot during
operation. The operator is obliged to
ensure that due care is taken to
protect third parties (small children
in particular).
GAS HEATER OPERATING
INSTRUCTIONS
a = Control knob Thermostat)
b = Integrated control switch for the
Trumavent fan TEB
c = Pressure igniter (model Trumatic S
3002 P)
d = Automatic ignition device with battery
compartment (model Trumatic S 3002/S
5002)
e = Remote ignition display (special
accessory)
f = Window to check flame
g = Thermostat sensor
h = Name plate (remove cover)
AUTOQUEST / AVANTGARDE GAS
HEATER - OPERATION WITH THE
PIEZO IGNITOR (S 3002 P ONLY)
1. Turn on gas cylinder and open quick-
acting valve in the gas supply line.
2. Turn control knob (a) to thermostat
setting 1 - 1 0 and press it down as far
as the stop. At the same time keep
operating the piezo ignitor rapidly until
the flame ignites.
3. Keep the control knob pressed down
for a further 10 seconds to allow the
safety pilot to operate.
4. Observe through the inspection
window for a further 10 seconds so as
to check that the flame has not been
extinguished due to air in the line
caused by a change of gas cylinder).
Equipment Use
Explorer Group 2005 Motorhome Handbook
33