Specifications

30
Equipment Use
1 Test button to check both internal and
external temperature and to set the clock.
2 Test button to check the voltage of the
leisure battery (B2), car battery (B1) and
to set the clock.
3 Test button to check the level in % of the
drink water tank and to set the clock.
4 Awning light switch, it turns off when
ignition is on.
5 Main switch.
6 Water pump switch.
7 Lights main switch.
8 Digital displaying of the required test.
9 It shows the starting up of the battery
parallel when the engine is started.
10 It shows the car (B1) battery test, the
blinking means run down battery alarm.
11 It shows the leisure (B2) battery test, the
blinking means run battery alarm.
12 It shows the battery recharging through
engine alternator.
13 It shows the test or alarm batteries
together with the symbols 10 or 11.
14 It shows the connection to the 230v net.
15 It shows that the minimal voltage device
has switched on.
16 It shows the drink water test tank, the
blinking means empty tank alarm.
17 The blinking means full waste water tank
alarm.
18 It shows the unit of measure: U=Volt,
I=internal temperature, E=external
temperature.
Note: The clock is supplied from the leisure
battery (B2). Should B2 be disconnected, the
clock is able to keep working, without
visualisation, for about 2 weeks.
DIP-SWITCH POSITION
Attention: Do not change the position as
shown in illustration below.
ON 1 2 3 4
CONTROL PANEL "PC-200 EX" AUTOCIRRUS/CALYPSO/AUTOSTRATUS/CASTAWAY