User Manual

11
Operating Instructions
This grill is designed to operate with a 1 lb.
7.75 in. or 10.6 in. high disposable / 16.4 oz. or 14.1 oz. propane gas tank (DOT 39 Cylinder) (Figure 1).
DO NOT ATTEMPT TO REFILL ANY 1 lb. (16.4 oz. or 14.1 oz.) PROPANE GAS TANKS!
Connecting LP Gas Tank
Only cylinders marked “propane” may be used.
W CAUTION: The gas pressure regulator provided with this appliance must be
used. Replace only with regulator model # R801 / KR-101.
Note: 1 lb cylinders may form frost when near empty.
1. Make sure the regulator/control knob is in the “
OFF” position (Figure 2).
2. Lubricate the threads of the regulator/control knob with petroleum jelly. Line up threads on LP gas
tank with regulator/control knob.
3. Insert and rotate LP gas tank clockwise until they fit snugly together. HAND TIGHTEN ONLY. Be
careful not to crossthread when screwing in tank (Figure 3).
4. Perform leak test per “Checking for Leaks” section.
Disconnecting LP Gas Tank
1. Turn the regulator/control knob to the “ OFF” position (Figure 2).
2. Rotate LP gas tank counterclockwise until it is detached (Figure 4).
3. Store the LP gas tank in a proper location, per instructions on the LP gas tank.
Checking for Leaks
Burner Connections
1. Make sure the regulator/control knob is securely fastened to the burner.
Note: The brass nut should be ¼ to ½ turn past tight. The regulator will rotate 360º even when the
brass nut is tightened.
If your unit was assembled for you, visually check the connection between the burner and
regulator/control knob (Figure 5).
W WARNING: Failure to inspect this connection or follow these instructions
could cause a fire or an explosion which can cause death, serious bodily
injury or damage to property.
2. If the burner and regulator/control knob do not fit properly or if you have any questions, please
contact 1.800.694.0013 for assistance.
Tank/Gas Line Connection
1. Make 2-3 oz. of leak detection solution by mixing one part liquid dishwashing soap with three
parts water.
2. Make sure regulator/control knob is in the “
OFF” position (Figure 2).
3. Spoon the leak detection check solution on all “X” locations (Figure 5).
a. If any bubbles appear, remove the LP gas tank and reconnect, making sure the connection is
secure.
b. If you continue to see bubbles after several attempts, remove the LP gas tank per
“Disconnecting LP Gas Tank” section, and contact 1.800.694.0013 for assistance.
c. If no bubbles appear after one minute, turn regulator/control knob to the “
OFF” position,
wipe away solution and proceed.
First Use
1. Make sure all labels, packaging and protective films have been removed from the grill.
2. Remove manufacturing oils before cooking on this grill for the first time by operating the grill for at
least 15 minutes on
(HIGH) with the lid closed. This will “heat clean” the internal parts and dissipate
odors.
Figure 1
1 lb
453 g
7.75 in. / 19,7 cm
3.875 in. / 9,8 cm
2.9 in. / 7,4 cm
1 lb
465 g
10.6 in. / 27 cm
Figure 2
PUSH
PRESIONE
O
R
－
P
L
－
1
0
1
B
E
S
P
O
R
T
R
E
G
U
L
A
T
Figure 3
Figure 4
Figure 5
X
X