User guide

Please consult your network manager to ensure that multicast polling is allowed on your
system. Your network manager may also allocate a specific IP address and Port range that
may be used by the Rdb Native Drivers, and you should change your server and session
configuration files to reflect these allocated addresses.
Setting the Multicast Base port to zero (0) will effectively disable multicast broadcast and
receipt for that server. This also means that the server will not respond to any POLL
requests issued by the Controller.
Contents
6.5 Client Operations
6.5.1 Showing Clients
Information about clients within active servers may be displayed using the controller.
You must provide a valid control password for the server.
Clients will only be displayed for those servers where the control password matches the
control session control password.
6.5.1.1 Interactive mode
The control commands available to show clients can be seen in Table 6–18 Interactive
Show Clients.
Table 6-18 Interactive Show Clients
Command
Description
show active clients
show all clients
Shows all clients on responding servers.
show active clients <name>
show all clients <name>
Shows all clients with username <name> on
responding servers
show active clients in
<database_spec>
show all clients in <database_spec>
Shows all clients currently connected to the specified
database on all responding servers
show clients Shows all clients in the currently connected server
show clients in <database_spec> Shows all clients currently connected to the specified
database on the currently connected server
90