User guide

- 4 -

HARDWARE INSTALLATION

NOTE: Use the AC adapter included with this unit ONLY. Using the

incorrect AC adapter will result in permanent and

unpredictable damage to the USB/PCMCIA Portable Hard

Disk.

1. Connect the 36-pin connector from the USB cable to the interface

connector on Portable Hard Disk. Press firmly until the connector is

seated.

2. Connect the AC adapter into the DC IN jack at the rear panel of the

Portable Hard Disk.

3. Make sure the Power Source Switch is at the DC position.

4. Attach the AC adapter to the AC power outlet.

5. Follow the Software Installation for the next steps.

Push

Switch to DC position