Owner manual
Table Of Contents
- CONTENTS
- INTRODUCTION
- SYSTEM REQUIREMENTS
- PART NAMES AND FUNCTIONS
- HARDWARE INSTALLATION
- SOFTWARE INSTALLATION FOR WINDOWS 95/98
- SOFTWARE INSTALLATION FOR WINDOWS Me
- SOFTWARE INSTALLATION FOR WINDOWS 2000/XP
- SOFTWARE INSTALLATION FOR WINDOWS NT
- SOFTWARE INSTALLATION FOR DOS/WINDOWS 3.1
- SOFTWARE INSTALLATION FOR OS/2 WARP
- USING CD-RW WITH PCMCIA INTERFACE
- 6 -
HARDWARE INSTALLATION
Note:
♦ This external CD-RW should only be powered by the AC adapter provided by manufacturer,
using an incorrect AC adapter can result in permanent and unpredictable damage to the drive.
♦ This external CD-RW supports Hot Insert/Remove function only under Windows
95/98/Me/2000/XP, with the other operating systems, please insert the PC Card of interface
cable before power-on computer, and remove this card after power-off computer.
1. Insert the plug of the PCMCIA interface cable into the Interface Connector of drive. Press firmly
until the interface connector is seated correctly.
2. Connect the AC adapter lead to the Power Jack (DC IN) at the rear panel of the drive. Attach the
AC adapter to the AC power outlet.
3. Place the CD-RW drive in the horizontal position. This drive is designed to operate only in the
horizontal position. Operating the CD-RW drive in any abnormal position is not recommended.
4. You are now ready to install the device drivers, please follow the related software installation guide
to install the device driver.