User Manual

- -
6
• When the drive is in ‘play’ state, pressing the right edge of the button
will skip to the next track.
• When the drive is in ‘play’ state, pressing the left edge of the button will
skip to the previous track.
†† Headphone Volume Control knob:
Turn this rotary knob to adjust the headphone volume.
‡‡ Headphone jack:
This is a 3.5mm audio headphone jack.
ˆˆ Line-out jack:
Audio outputs signal to an amplifier.
REAR PANEL OF THE CD-ROM DRIVE:
•• PCMCIA/Parallel Port Interface connector:
This connector connects to the PCMCIA interface card or the Parallel
Port interface cable.
‚‚ Power Source switch:
• Set the switch to “PC” to select the power source from PCMCIA socket.
• Set the switch to “DC/BATT” to select the power source from AC
adapter or batteries.
Please refer to next section titled “CD-ROM POWER SOURCE” for
details.
ƒƒ DC-IN jack:
This jack connects to an AC adapter.
„„ Power button: (for stand-alone CD player operation only)
Press this button to power on/off the drive when it is used stand-alone as
an audio CD player.
Figure 2