User Manual

- -

It is not necessary to remove the PCMCIA interface card from the CD-ROM

drive when the CD-ROM is in stand-alone mode. You may store the card in

the cardholder at the back panel of the drive.

The following control buttons will be used in stand-alone mode.

Power Button

• Press the POWER button will turn on the PCMCIA CD-ROM in stand-alone

mode. Press the POWER button again will turn off the drive.

• The PCMCIA CD-ROM will spin in a lower speed (single speed) in stand-

alone mode.

• As another power saving feature, the PCMCIA CD-ROM will be

automatically turned off if it has not played for approximately 40 seconds.

Play/Pause Button

• Press this button will activate the drive to begin playing.

• If the drive is in play state, pressing this button will make it pause.

• This button will work in the audio CD playing mode only..

Next/Previous Button

• In the play state, press the right edge of the button to skip to the next track.

• Press the left edge of the button to skip to the previous track.

• This button will work in the audio CD playing mode only..

Volume Control Knob

• Use this knob to adjust the headphone volume.