Specifications

Chapter 4: Kiosk and Desktop Station Installation and Setup
4 – 8
Notes
Desktop Encoder specifications
Connect the Desktop Encoder to the PC
1 Set up the Desktop Encoder next to the PC that it will be
connected to. Make sure that the PC is connected to the
network where the B.A.S.I.S.® database resides.
2 Open the Desktop Encoder by unlocking the enclosure and
sliding out the enclosure to uncover the card hopper.
3 Load blank cards into the card hopper as shown in
Figure 4.4.
4 Put the weight on top of the cards as shown in Figure 4.4.
5 Close and lock the Desktop Encoder.
6 Connect the Desktop Station to the COM 1 serial port on
the PC.
7 Connect the power cable of the Desktop Encoder to a
power outlet.
To convert a standard computer with the requirements listed
above to a Stanley ID Express Station™ desktop station, you
will need to perform a series of tasks.
These tasks include:
■ setting up .NET security
■ configuring network IP addresses
■ installing the Stanley ID Express Station™ kiosk applica-
tion
■ configuring kiosk networking
■ configuring the Microsoft® Internet Explorer® browser
See the Stanley ID Express Station™ Installer Guide for com-
plete instructions on configuring the desktop station to run on
your network or if you are familiar with networking, see the
section below.
Specification Requirements
Operating temp 0° – 40°C (32° – 104°F)
Storage temp 0° – 45°C (32° – 113°F)
Operating
humidity
10% – 90%
Storage
humidity
10% – 85%
Power Standard 120VAC, 20 amp wall
outlet