Manual

6.3 H
YPER
T
ERMINAL
S
ETTINGS
The first time that you run Hyperterminal, you will be prompted to create a new connection. In
the following example, we will create a connection called BlueConnect. Enter the name and
click on OK to continue.
The next dialog will have a header entitled Connect To. Set the Connect using setting to use the
COM port that you discovered in Section 6.1: 6.1Discovering the VCOMM Port. Click on OK
to continue.
The next dialog will have a header entitled “COM[X] Properties”. You can set the “Bits per
second” to any value. A baud rate of 38400 will work quite well. Set “Flow Control” to None.
Then click on OK to immediately connect to the specified COM port.