F1ULTRA Instruction Manual

REAR RIDE HEIGHT
SET UP TIPS
Using a long on road ride height gauge, mea-
sure the 3 locations shown here in this order;
A Rear pod height (ie 5mm). Measure the pod.
B Center link height (ie 5mm). Measure the
front of the pod.
C Rear chassis height (ie 5mm). Measure the
back of the chassis.
NOTE- The wheels must be attached and
battery installed.
To change the ride height change it in this
order;
A Change bearing cams for height A
B Adjust the top shock turnbuckle for height B
(longer link raises the B setting)
C Adjust the 2 micro shock collars for height C
(lowering the collars raises the rear chassis).
FRONT RIDE HEIGHT
Change the front ride height by changing the
bulkhead plate thickness (Exotek Options) or
using 3mm metal shims. Change m3 screws as
needed for proper length and durability.
Do not change the steering knuckle shimming
to change ride height as the pins may rub the
wheels. You may need to add shims under the
steering post for extreme low ride heights.
REAR TRACK WIDTH
Widen the rear wheels using axle spacers for
more rear grip and stability. Narrow the width
for more steering.
A
A
B C
C B
RIDE HEIGHT SHIM
IMPORTANT- Insure you
have enough ride height
here or you may experience
a car that is loose in corners
due to the chassis scraping
the ground at high speed.
5MM 5MM 5MM
28