F1ULTRA Instruction Manual

SUGGESTED LAYOUT OF YOUR ELECTRONICS

86421

M4 Locknut (x4)

ENSURE THE SHOCK

DOES NOT RUB THE BODY.

TRIM BODY IF NEEDED

BODY SELECTION MOST NEWER BODIES

(2017 AND NEWER) BY BITTY, MONTECH,

PROTOFORM ETC WILL WORK WITH THE F1ULTRA

TO REMOVE THE BATTERY:

1. TURN THE LIPO STRAP

2. LIFT THE LEFT SIDE OF

BATTERY UP

3. SLIDE TO THE LEFT.

USE THIN 16GAUGE WIRE

FOR THE MOTOR. ROUTE

WIRES AWAY FROM THE

SHOCKS

ATTACH ESC AND

RECEIVER WITH 3M TAPE

R4113

M3x8 BH (x2)

R4113

86421

RUN SENSOR WIRE DOWN

THE CHASSIS GROOVE AND

COVER WITH ANY DECAL

R4128

5x10mm BEARING (X4)

R4128 (X2)

OPTIONAL:

REMOVE M3

NUT AND ATTACH

ANTENNA

MOUNT IN

ITS PLACE

R4094

R4125