Users Manual

13


BatteryPack
TheMD‐100devicehasonesmall,permanent,internalbatteryandonehot‐swappablebattery.When
hotswappablebatteryhaslowvoltageandneedstobereplaced,thebuilt‐inbatterywillpowerthe
tabletforupto10minutes.
TochargetheBatteryPack:
1. Connectthepowercabletothechargingportonthedevice.
2. Connectthepoweradaptertoanelectricaloutletandchargethetabletuntilthebatteryisfully
charged.
3. Afteryourdeviceisfullycharged,disconnectthechargerfromboththedeviceandtheelectrical
outlet.
4. Additional
hot‐swappablebatteriescanbechargedindependentlyoftheTabletPCbyplacing
thebatteryintoadockingstationwithabatterychargingbay(availableseparately).
NOTE:Topreventdamagetobatteries,pleaseseeSection8:Safety

Batterylifenaturallydegradesovertime.Failuretofollowinstructionsforrecommended
operating
temperatures,chargeanddischargerates,andotherinstructionsmayaccelerate
batterydecayrates.Ifyourtabletbatterywillnotacceptorholdasatisfactorycharge,itmayneed
tobereplaced.
Forbatterystorageandchargingtemperatures,seeSection8:Safety

CheckingtheBatteryLevel
TocheckthebatterychargeleveloftheMD‐100,youmayusethebatterymonitorwithinWindows
operatingsystemorthevoltagegaugeofhotswappablebatterypack.
WhenthehotswappablebatterypackisnotinstalledintheTabletPCandyouwanttoknowthebattery
level,press
theBatteryTest(1)button. Thegaugewilldisplaythecurrentbatterychargelevel.