User's Manual

18
19
How to Mount the CO Alarm
Drywall
Plastic Anchors
Mounting Bracket
1” Screws
Situation B: No Wood
If no wood is present, use a Phillips
screwdriver to screw the two plastic
wall anchors into the pre-drilled holes
until fully seated. Then secure the
mounting bracket to the wall anchors
using the two 1” screws.
Situation C: Combination
Where there is no wood present, first
screw the plastic wall anchor into
the pre-drilled hole using a Phillips
screwdriver.
Then secure the mounting bracket in
place using the two 1” screws.
Drywall
Plastic Anchors
Mounting Bracket
1” Screws
Wood
4 Lock Into Place
With the alarm activated and the alarms
fully networked together, position the
CO alarm onto the center of the bracket
and turn clockwise. The alarm will lock
into place.
Alarm Specifications (EX20 CO/EX20C CO)
Operating Voltage 3VDC
Battery Type Non-replaceable Lithium-Manganese
Sensitivity 70 PPM: 60 to 80 minutes
150 PPM: 10 to 15 minutes
400 PPM: 4 to 8 minutes
30 PPM or less: alarm will not activate
Alarm Life Up to 10 Years
Operating Ambient Temperature 40°F - 100°F
Operating Humidity 10 - 95% Non-condensing
Alarm Dimensions 5.1” x 5.1” x 1.75”
Weight 0.86 lbs
Heat Sensing
Fixed Temperature 135ºF
Rate of Rise 20ºF / minute, > 100ºF
Listings c UL us; CSFM
FCC Compliance Statement and IC Notice:
This device complies with part 15 of the FCC Rules. This device complies with Industry
Canada licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning this equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
(1) Reorient or relocate the units. (2) Increase the separation between the equipment
and receiver. (3) Connect the equipment into a different circuit from that to which the
receiver is connected. (4) Consult the dealer or an experienced technician for help.
FCC Caution and IC Caution: Any Changes or modifications not expressly approved by
the manufacturer could void the user’s authority to operate the equipment.
Les changements ou modifications non approuvés expressément par la partie
responsable de la conformité pourrait annuler l’autorité de l’utilisateur à faire
fonctionner l’équipement.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
Exigent CO Manual 102913.indd 18-19 10/29/2013 7:44:56 PM