User's Manual

EX7100 Technical Manual - Configuring the Terminal
©1999 Exicom Technologies (1996) Ltd 3-16 Issue 1 - May 2001
Transmit Audio Line Level.
For each channel, the transmit audio line level is selectable in 0.5dB steps from
-15dBm to +3dBm.
1) From idle, press ‘Enter’.
Use the arrow keys to enter the First Level
password ‘1111’ and then press ‘Enter’.
2) Use the up and down arrow keys to make
sure the → is next to Exchange.
Press ‘Enter’.
3) Use the up and down arrow keys to make
sure the → is next to Tx Level.
Press ‘Enter’.
4) Use the keypad to set the required Tx audio
line level for each channel. Press ‘Enter’ to
accept changes for each channel.
NB: All channels may be set to the same
value by selecting ‘ALL”.
(Note: Within a terminal the Tx line level
should not be set lower than the Rx line
level. For typical applications with short
telephone cable runs, a Tx line level of
0dBm is recommended)
5) Press ‘Escape’ to back out of the menu.
Receive Audio Line Level.
For each channel, the received audio line level is selectable in 0.5dB steps from
-15dBm to +3dBm.
1) From idle, press ‘Enter’.
Use the arrow keys to enter the First Level
password ‘1111’ and then press ‘Enter’.
2) Use the up and down arrow keys to make
sure the → is next to Exchange.
Press ‘Enter’.
3) Use the up and down arrow keys to make
sure the → is next to Rx Level.
Press ‘Enter’.
Password ∗ ∗ 1 ∗
↑
PSU monitoring
→Exchange
Metering
→tx level
Password ∗ ∗ 1 ∗
↑
PSU monitoring
→Exchange
Tx level
→rx level
Ch: 1 lv: 0 dBm
↑