User's Manual

EX7100 Technical Manual - Configuring the Terminal
©1999 Exicom Technologies (1996) Ltd 3-5 Issue 1 - May 2001
Changing the Time and Date.
The Time and Date should be changed to reflect local settings. Note that the date field
follows the UK format: DD/MM/YY.
1) From idle, press ‘Enter’
Use the arrow keys to enter the First Level
password ‘1111’ and then press ‘Enter’.
2) Use the up and down arrow keys to make
sure the →
→→
→ is next to Controller.
Press ‘Enter’.
3) Use the up and down arrow keys to make
sure the →
→→
→ is next to Set Time/Date.
Press ‘Enter’
4) The current time and date is displayed. As
in the example at the start of this section,
use the arrow keys to change the time and
date to the required local settings and then
press ‘Enter’
The new time takes effect when the ‘Enter’
key is pressed.
5) Press ‘‘Escape’’ until the display returns to
idle
Operating Mode.
Ensure that this parameter is set to either:
> Terminal 100% (link is continually up),
> Terminal On Demand (link is up only with traffic),
> Repeater 100% (terminal configured as a repeater transmitting continually),
> Repeater On Demand (terminal configured as a repeater transmitting only with
traffic).
1) From idle, press ‘Enter’
Use the arrow keys to enter the First Level
password ‘1111’ and then press ‘Enter’.
2) Use the up and down arrow keys to make
sure the →
→→
→ is next to Controller.
Press ‘Enter’.
3) The screen will read Operating Mode.
Press ‘Enter’
Password ∗ ∗ 1 ∗
↑
Operating mode
→set time/date
1201:01 01/01/98
↑
→Controller
RF PARAMETERS
→operating mode
set Time / date
Password ∗ ∗ 1 ∗
↑
→Controller
rf parameters