User's Manual

EX7100 Technical Manual - Mandatory Regulations
©1999 Exicom Technologies (1996) Ltd Regulations-2 Issue 0 – October 2000
1.0.5 Telecom Safety Earth
The wire used for safety earthing should be a minimum of 4mm
2
and should preferably be
directly connected to an earthing stake driven into the ground
Refer to Section 2.8 of the Technical Manual for specific instructions
2.0 Country-specific Regulations
The following sections detail any regulations that may be required by specific countries
and/or territories.
2.0.1 New Zealand Regulation - PTC 200
• “The grant of a Telepermit for any item of terminal equipment indicates only that
Telecom has accepted that the item complies with minimum conditions for connection
to its network. It indicates no endorsement of the product by Telecom, nor does it
provide any sort of warranty. Above all, it provides no assurance that any item will
work correctly in all respects with another item of Telepermitted equipment of a
different make or model, nor does it imply that any product is compatible with all of
Telecom’s network services.”
• “This equipment may not provide for the effective hand-over of a call to another device
connected to the same line.”
• “IMPORTANT NOTICE
Under power failure conditions, this device may not operate. Please ensure that a
separate telephone, not dependent on local power, is available for emergency use.”
• “Use of pulse dialling, when this equipment is connected to the same line as other
equipment, may give rise to bell tinkle or noise and may also cause a false answer
condition. Should such problems occur, the user should NOT contact the Telecom
Faults Service.”
• “Devices designed to respond to particular ringing cadences may not respond when
used with this equipment.”
• In the event of any problem with this device, it is to be disconnected and a CPE item
connected to one of its terminal ports may be connected directly in its place. The user
should then arrange for the product to be repaired. Should the matter be reported to
Telecom as a wiring fault, and the fault be proven to be due to this product, a call-out
charge will be incurred.”
• “Note that the receive audio line level must not be more than 3dB higher than the
transmit audio line level. (for typical installations using short telephone cable lengths, it
is recommended that the receive audio line level is set for –3dBm)”
• “The maximum number of parallel CPE devices that can satisfactorily be operated on
a single port is two (2)”
• “This unit should be powered from a supply that is compliant with AS/NZS3260 and is
SELV compliant”