User's Manual

EX7100 Technical Manual - Installation of Antenna and Equipment
©1999 Exicom Technologies (1996) Ltd 2-12 Issue 2 - February 2001
It is now recommended that you proceed to Section 3 ‘Configuring the Terminal’, to
ensure that the EX7100 terminal has been configured for your specific application.
2.11 Final Antenna Alignment
2.11.1 General
This part of the installation requires two people, or one person with an analogue voltmeter
plugged into the terminals front panel monitoring point. The voltmeter leads need to be
long enough for the installer to view the display while rotating the antenna.
You will also need to refer to Section 3 of this Manual for instructions on using the
EX7100’s front panel.
Do not stand in front of the antenna, as electromagnetic radiation
may be hazardous to your health. Leave at least 1 metre between
the installer and the antenna as shown below
Figure 2.8: Antenna Alignment
2.11.2 Alignment Sequence
1) Set up a Test Link by following the
procedure outlined in Section 4.3.1.
2) Use the up and down arrow keys to
make sure the →
→→
→ is next to Antenna
Align and then press ‘Enter’
12345678
→antenna align