User's Manual

EX7100 Technical Manual - Mandatory Regulations
©1999 Exicom Technologies (1996) Ltd Regulations-1 Issue 0 – October 2000
Mandatory Regulations
The following information outlines the mandatory regulations governing the installation
and operation of the Exicom EX7100 digital radio link.
Adherence to this information is necessary to ensure regulatory compliance.
1.0 General Requirements
This equipment shall be configured only with those assemblies as specified in the
Technical Manual and shall only be mounted as instructed.
1.0.1 Danger
The Modem/Controller module contains a lithium battery. There is a danger of explosion if
the battery is incorrectly replaced. Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the manufacturers instructions. Do not recharge,
disassemble or incinerate.
1.0.2 Warning
This equipment must only be installed and maintained by service personnel.
1.0.3 Access to the Equipment
The EX7100 digital radio link should be installed in a location or environment that
prevents unauthorised access.
1.0.4 Equipment Port and Connector Classifications
The EX7100 digital radio link contains various ports and connectors that are classified as
either Safety Extra Low Voltage (SELV) or Telecommunication Network Voltage (TNV) as
follows:
SELV TNV
> DC Power Input
> G.703 (3x ports)
> I/O
> Sync Data
> Control
> LMS
> Front Panel Test Pin Sockets
> Line Interface Module Connector
Connect SELV circuits on this equipment
only
to other SELV compliant circuits as
defined in AS/NZS 3260 and IEC950.
Connect TNV circuits on this equipment
only
to other TNV compliant circuits as
defined in AS/NZS 3260 and IEC950