User's Manual

EX7100 Technical Manual - Configuring the Terminal
©1999 Exicom Technologies (1996) Ltd 3-4 Issue 1 - May 2001
4) You will be asked to enter the old Second
Level password. If this is still set to the
factory default value, use the arrow keys
to enter ‘1234’, then press ‘Enter’
5) You will be asked for the new
Second
Level password. Use the arrow keys to
change the old password to the required
new password and press ‘Enter’
6) You will be asked to confirm the new
password. Use the arrow keys to re-enter
the new Password, and press ‘Enter’
7) The new Second Level password is now
set. Press ‘‘Escape’’ until the display
returns to idle.
Disabling the Passwords.
1) From idle, press ‘Enter’
You will be asked to enter the password.
Note
this is the First Level password
which is factory fixed at ‘1111’
Use the arrow keys to enter ‘1111’, then
press ‘Enter’.
(Note: the up and down arrows increase
or decrease the number above the ↑
↑↑
↑
symbol)
2) Use the up and down arrow keys to make
sure the →
→→
→ is next to Controller.
Press ‘Enter’
3) Use the up and down arrow keys to make
sure the →
→→
→ is next to Passwords.
Press ‘Enter’
4) Use the up and down arrow keys to make
sure the → is next to ‘Disable Lo Lvl’, or
‘Disable Hi Lvl’.
Press ‘Enter’
5) You will be asked to enter the old
Second
Level password. If this is still set to the
factory default value, use the arrow keys
to enter ‘1234’, then press ‘Enter’
6) The password has now been disabled. To
re-enable the password, follow the same
process.
Old p/word: 0* * *
↑
New p/word: 0* * *
↑
Confirm p/w: 0***
↑
Password ∗ ∗ 1 ∗
↑
→Controller
RF PARAMETERS
Set Time / date
→passwords
change password
→Disable lo lvl
Old p/word: 0* * *
↑