User's Manual

EX7100 Technical Manual - Module Descriptions
©1999 Exicom Technologies (1996) Ltd 7-45 Issue 3 - May 2001
7. Re-connect all cables as removed in 4. above. Ensure that all cables are run as they
were prior to removal.
8. Inspect the EX7100 terminal to ensure that it is free of foreign material. Remove and
clean as required.
9. Connect the antenna to the terminal. Apply power to the EX7100 rear panel and
switch the terminal on.
10. If necessary, retune the Receiver Front-End module (refer to Section 7.8.3).
11. Reset the receive frequency and other variables as necessary (refer to Section 3 as
required)
12. Return to normal operating mode and check that the link is correctly established. If
not refer to Section 7.8.2 above and Section 5 “Troubleshooting” as required.
13. Replace the bottom cover, taking care to tighten every screw. No screws should be
left over at the end of the job.
14. Re-install the EX7100 back into its rack and re-connect all necessary power,
signalling and antenna cabling.