User's Manual

EX7100 Technical Manual - Module Descriptions
©1999 Exicom Technologies (1996) Ltd 7-21 Issue 3 - May 2001
6. Inspect the EX7100 terminal to ensure that it is free of foreign material. Remove and
clean as required.
7. Connect the antenna to the terminal. (Caution:
do not proceed until this is done to
avoid damage to the PA module). Apply power to the EX7100 rear panel and switch
the terminal on.
8. If necessary, retune the Transmitter output filter (refer to Section 7.4.3 above).
9. Set the Transmitter, Receiver and RF Power Amplifier module configuration variables
as these are all carried by the microcontroller on the Transmitter module (refer to
Section 3 as required).
10. Return to normal operating mode and check that the link is correctly established. If
not refer to Section 7.4.2 above and Section 5 “Troubleshooting” as required.
11. Replace the bottom cover, taking care to tighten every screw. No screws should be
left over at the end of the job
12. Re-install the EX7100 into its rack and re-connect all necessary power, signalling and
antenna cabling.