Instructions / Assembly

Step 1:

Attach stake base (B) to top pole (A) by screwing

it to the right until it is firmly tightened.

Step 2:

Add pellet seeds (longer than 5mm) into opening

located in the back.

Top Pole

Stake Base

Note:

Product (top pole) will vary depending on the item purchased.

When everything is assembled, insert stake base firmly into the ground. For best results, install on flat ground and

ensure that the stake is 90 degrees vertical to the ground.





19658-RS

PAGE 1
19658-RS Note: Product (top pole) will vary depending on the item purchased. Stake Base Top Pole Step 1: Attach stake base (B) to top pole (A) by screwing it to the right until it is firmly tightened. Step 2: Add pellet seeds (longer than 5mm) into opening located in the back. When everything is assembled, insert stake base firmly into the ground.
PAGE 2
OPERATION ON/OFF: The unit is shipped in the OFF position. Locate the ON/OFF button on the bottom of the unit and slide it into the ON position (Photo #1). In the ON position, the solar cell will light up automatically at dusk and will shut OFF automatically when the solar panel is exposed to daylight. Location: Select a sunny location. Place the unit in direct sunlight for at least one day to fully charge the battery.