Instructions / Assembly

Solar Unit Flower (2)

Middle Flower

Cylinder Nut Bolt (2)

Stake Base

Stake Support

Leaf Pole

Middle Pole Hex Wrench

Step 1:

Attach flower (B) to leaf pole (H) by using the

nut bolt (E). Use hex wrench (J) to tighten nut

bolt (E). Repeat step for the other side.

Step 2:

Place solar unit (A) firmly on top of the

cylinder (D).

TROPICAL KINETIC SPINNER

Assembly Instructions

PAGE 1
TROPICAL KINETIC SPINNER Assembly Instructions Step 1: Solar Unit Flower (2) Stake Base Stake Support Attach flower (B) to leaf pole (H) by using the nut bolt (E). Use hex wrench (J) to tighten nut bolt (E). Repeat step for the other side. Middle Flower Leaf Pole Step 2: Cylinder Middle Pole Nut Bolt (2) Hex Wrench Place solar unit (A) firmly on top of the cylinder (D).
PAGE 2
Step 3: Place middle flower (C) on top of leaf pole (H). Then place solar unit (A) (the result of step 2) firmly on top of leaf pole. Step 4: Attach leaf pole (H) to middle pole (I) by turning it to the right until it is firmly tightened. Lay Assembly on the ground for the following steps. Step 5: Slide stake support (G) into stake base (F) by inserting it through the top.