Instructions / Assembly

Photo 4
Photo 3
OFF
ON
Photo 1
Photo 2
OPERATION
ON/OFF: The unit is shipped in the OFF position. Locate the ON/OFF switch on the bottom of
the base and slide it into the ON position (Photo #1). In the ON position, the solar cell will
light up automatically at dusk and will shut OFF automatically when the solar panel is
exposed to daylight.
Location: Select a sunny location. Place the unit in direct sunlight for at least two full days
with the power switch in the ON position to fully charge the battery. The more direct sunlight
your new solar light is exposed to during the day, the longer the light will operate in the
evening. Make sure no artificial light (street lights, house lights, etc) will shine on the solar
light as this will not allow the solar light to turn on at night.
TIPS
Make sure switch is in the ON position by taking the stake indoors in a dark area and
covering the top. Check and see if the light is turning on by moving the switch to the ON and
OFF position.
If the light does not turn on, please unscrew the bottom of the base (see maintenance
section) and verify that the battery is properly placed in the battery compartment.
1. If the battery is not in the correct position, please fix and then set outdoors again in
direct sunlight for at least 2 full days with the power switch in the ON position.
2. If the battery was in the correct position, contact 1-800-775-5503 or
[e-mail] so we may rectify the issue.
MAINTENANCE
Cleaning: The solar panel has an epoxy cover that will need to be kept free of dirt and debris,
and snow, all the time. Wipe the panel periodically with a damp cloth. Failure to do so will
prevent the battery from charging properly, reducing operating time and the life of the battery.
Check the battery periodically, especially after winter months, and replace when necessary.
The battery may need to be replaced after a year of continuous use. To replace, open the
battery compartment by unscrewing the two screws below the base (Photo #2) and pulling
the battery cover off the unit (Photo #3). Replace the battery with a 1/3 AAA Ni-MH 100mAh
1.2V rechargeable battery (Photo #4). The capacity of the replacement battery shall not be
less than the recommended capacity. Replace the battery cover and screw two screws in
firmly to seal the unit.
Warning:
• Only use rechargeable 1/3 AAA Ni-MH 100mAh 1.2V battery.
• Failure to insert the battery in the correct polarity, as indicated in the battery compartment,
may shorten the life of the battery or cause the battery to leak.
• Do not dispose of batteries in fire, or heat, as battery may explode.
• Do not open, short circuit, or mutilate battery, as injury may occur.
• Batteries should be recycled, or disposed of, in accordance with Federal, state and local
regulations.
• Electrical rating is 0.05W.
Ni-MH
Battery must be recycled or
disposed of properly. Do not
short circuit or dispose of in re.
FOR DECORATIVE USE IN THE GARDEN. NOT TO BE GIVEN TO CHILDREN AS TOY.
© 2021 Exhart - Chatsworth, CA 91311. Made in China / Fabrique en Chine. All Rights Reserved.
For help please call 1-800-775-5503 | [e-mail]
exhart.com