Instructions / Assembly

Kinetic Bird Feeder

Assembly & Care Instruction

A. Large Cap Nut (2)

B. Nut (2)

C. Cap (2)

D. Basket (5)

E. Wrench

F. Support Rod (6) (1 extra)

G. Lock Washer (12) (2 extra)

H. Small Cap Nut (12) (2 extra)

I. U-Bar

J. Pole (2)

K. Stake Support

L. Stake Base

M. Wheel (2)

1. Attach either wheel (M) face-out on U-bar (I) by inserting threaded

portion through center hole of wheel. Then, screw on nut (B) and

tighten firmly with wrench (E). Next, place cap (C) over the nut and

secure it with one of the large cap nuts (A). Tighten with wrench (E).

Repeat this process to attach the second wheel.

3. Attach poles (J) to U-bar (I) by first, slipping one of the poles (J)

directly into bottom of the U-bar until the button locks. Then, slip the

second pole into the first pole until the button locks. Next, slide in

stake support (K) over the stake base (L). Finish assembly by slipping

in the stake base (L) to the open end of that last pole until the button

locks. When everything is assembled, total height of Ferris Feeder

should be close to 7ft tall. Insert into ground and make sure it is

standing straight.

Lay assembly on the ground for the following steps.

2. Line up wheel colors to ensure that the basket support rods will line

up with their respective holes. Attach basket support rods (F) using

lock washers (G) and small cap nuts (H). Tighten firmly. Repeat for all

rods. Hang baskets (D) from basket support rods by placing the

baskets over the support rods and pushing down.

G H