Owner manual
Table Of Contents
- Certification Information
- 1 Introduction
- 2 Safety Information
- 3 Getting Started
- 4 W2CM-10Gb Ethernet Interface Series
- 5 Maintenance
- 6 Troubleshooting
- 7 Warranty
- A Technical Specifications
- Index
Introduction
QualityAssurer 805 7
Physical Description of QA-805 Unit
Rear FRU Physical Layout
Logic Ground
Logic ground is used as reference for low voltage electronics and is
isolated from the chassis/shelf ground and 48 V power lines. For EMI/EMC
purposes, it might be needed to connect the logic ground and shelf ground
together.
To connect both grounds, a screw with a conductive metal washer is
installed in this location (GND) as shown in the following picture. To
disconnect, remove this screw.