Owner's manual

Setting Up DSL/IP Tests
VDSL2/ADSL2+ Multi-play Test Set 57
Setup
Application Settings
Before executing the DSL/IP tests, the Application Settings function allows
you to set general settings and identification fields.
To access Application Settings:
From the Home pane, select DSL/IP Tests, Setup, and then
Application Settings. The following parameters are available to
configure:
General
The General tab allows you to configure the unit with
specific measurement values.
 Report Format is MaxTester, HTML, MHTML, or
XML as the generated report format.
 Result File Storage Location allows you to select
where to save your results: to a USB or the internal
memory of the MaxTester
 Prompt To Save Results allows you to
Enable/Disable popup confirmation messages
before leaving a test and not saving results.
 Show Time Beep allows you to select the time
span for a beep from 0 to 3 seconds.
To access the parameter values:
1. Press the up/down arrow keys to highlight the desired parameter.
2. Press the left/right arrow keys to view and select the options.
OR
3. Press on a value to open a list box of options.
4. Press to confirm the value.