Owner's manual

Setting Up DSL/IP Tests
VDSL2/ADSL2+ Multi-play Test Set 37
Test Configuration
 Static IP is the address of the current location assigned by the
service provider. This entry is available only if Obtain IP is set to
Static.
 WAN Login Timeout is a numeric setup entry.
The following parameters are available only when Access Mode is IPoA or
Static.
 IP Address is the address for the unit that is actively connected to
your network or the internet at the time of login.
 Gateway is the IP address of the default gateway.
 Verify Gateway can be set to Enable or Disable.
 Subnet Mask is the network address used to identify if the IP
address is within the same wide area network.
 DNS1 is the address of the primary domain name server to be used
by the unit. If DNS is unavailable, enter 0.0.0.0.
 DNS2 is the address of the secondary domain name server to be
used by the unit. If DNS is unavailable, enter 0.0.0.0.
The following parameters are available only when Test Interface is
Ethernet.
 WAN/LAN Link Speed is a choice between Auto (negotiated
during the link establishment), 100 or 10 Mbit/s.
 WAN/LAN Connect Mode is Full- or Half-Duplex, when Link
Speed is set to either 100 or 10 Mbit/s.